Saftey Instructions - geo-FENNEL FTI 300 Mode D'emploi

EN
E

SAFTEY INSTRUCTIONS

INTENDED USE OF THE INSTRUMENT
The termal imaging camera FTI 300 is suitable for non-contact measurements of surface temperature
and enables an easy localisation of hot and cold spots on electrical and mechanical installations
CARE AND CLEANING
Handle measuring instruments with care. Clean with soft cloth only after any use. If necessary damp
the cloth with some water. If the instrument is wet clean and dry it carefully. Pack it up only if it is per-
fectly dry. Transport in original container / case only.
ELECTROMAGNETIC ACCEPTABILITY (EMC)
It cannot be completely excluded that this instrument will disturb other instruments (e.g. navigation sys-
tems); will be disturbed by other instruments (e.g. intensive electromagnetic radiation nearby industrial
facilities or radio transmitters).
CE-CONFORMITY
This instrument has the CE mark according to EN 61326-1:2013, IEC 61326-2-2:2012, IEC 61326-1:2012,
EN 61000-3-2:2014, EN 61326-2-1:2013, EN 61000-3-3:2013.
WARRANTY
This product is warranted by the manufacturer to the original purchaser to be free from defects in
material and workmanship under normal use for a period of two (2) years from the date of purchase.
During the warranty period, and upon proof of purchase, the product will be repaired or replaced (with
the same or similar model at manufacturers option), without charge for either parts or labour. In case
of a defect please contact the dealer where you originally purchased this product. The warranty will not
apply to this product if it has been misused, abused or altered. Without limiting the foregoing, leakage
of the battery, bending or dropping the unit are presumed to be defects resulting from misuse or abuse.
32