Panasonic EY4640 Instructions D'utilisation page 16

Battery charger (EY0L80)
1. Plug the charger into the AC outlet.
NOTE:
Sparks may be produced when the
plug is inserted into the AC power
supply, but this is not a problem in
terms of safety.
2. Insert the battery pack firmly into
the charger.
3. During charging, the charging lamp
will be lit.
When charging is completed, an in-
ternal electronic switch will auto-
matically be triggered to prevent
overcharging.
• Charging will not start if the battery
pack is warm (for example, immedi-
ately after heavy-duty operation).
The orange standby lamp will be
flashing until the battery cools down.
Charging will then begin automati-
cally.
4. When charging is completed, the
charging lamp will start flashing
quickly in green color.
5. If the charging lamp does not light
immediately after the charger is
plugged in, or if after the standard
charging time the charging lamp does
not flash quickly in green, consult an
authorized service center.
6. If a fully charged battery pack is in-
serted into the charger again, the
charging lamp lights up. After sev-
eral minutes, the charging lamp may
flash quickly to indicate the charging
is completed.
- 16 -