Getting Started - GBC EDNord DOCUBIND TL350 Manuel D'utilisation

DOCUBINDTL350
Cleaning
CAUTION: Unplug this product before cleaning.
• Wipe exterior only with a damp cloth.
Do not use detergents or solvents.
The following notes apply only to the units
rated 230V 50Hz.
MAIN CORDSET SELECTION
(FOR 230AV MACHINES ONLY)
When choosing a detachable line cord for use with the
DocuBind TL350, always observe the following:
The cordset consists of three components; the attachment
plug, cordage and appliance inlet. Each of these components
must meet European regulatory approvals for safety.
The following minimum electrical ratings for the specific
cordset are published for safety purposes. DO NOT USE
CORDSETS THAT DO NOT MEET THE FOLLOWING MINIMUM
ELECTRICAL REQUIREMENTS.
PLUG: 3A, 250 Volts, 50/60 Hz, Class 1,3 conductor,
European safety agency approved.
CORDAGE: Type H05W-F3G0.75, Harmonized ( HAR ).
The " " symbols indicate cordage approved to
appropriate European standard (NOTE: "HAR" may be
substituted by the approval mark of the European safety
agency which approved the cordage. An example would
be " VDE ".
APPLIANCE CONNECTOR: 3A, 250 Volts, 50/60 Hz,
European safety approved, Type IEC 320. Cordset shall not
exceed 3 meters in length. Cordset with component electrical
ratings greater than the minimum specified electrical ratings
may be substituted.
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500
Thank you for purchasing the GBC DocuBind
TL350. This system features our new, exclusive
wire holder design that enables you to assemble
your document as you punch, making it easier to
load paper onto the binding comb than previous
systems! The DocuBind TL350 advanced
punching technology also makes it easier to
punch more paper at once while providing
greater reliability.

Getting started

Push the handle (A) onto the shaft located on the right
1
hand side of the machine (see figure 1). Align the flat spot
of the handle with the flat of the shaft and secure it with a
screw-diver.
Insert U shaped wire support bracket into holes on top rear
2
of machine.
Firmly push the female end of the power cord into the
3
power cord receptacle (A1) located at the back of the
machine.
CAUTION: Make sure this step is complete prior to
plugging the male end of the power cord
into a power receptacle.
Plug the male end of the power cord into an appropriate
4
power receptacle.