Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
To prevent an unintended static stimulation, after the boundary has been set, be sure to set the static stimulation level on the collar back to level 1,
which is tone-only plus vibration.
Place the Boundary Markers
1. Using the same method as earlier, walk towards the warning zone until the collar beeps (10A).
2. Place the boundary marker in the ground along the boundary wire (10B).
3. Walk back into the pet area until the beeping stops.
4. Repeat this process along the warning zone until it is marked with boundary markers every 6 m (10C).
10A
Boundary
Wire
10B
10C
Boundary
6 m
Wire
15
Publicité
Table des Matières
