Granit SK I Mode D'emploi page 9

Cuts badly or not at all
Shaving head is hot
Clipper blades are blunt
Clipper blades have not been
correctly ground
Clipper blades have rust
Clipper blades are not oiled
Clipping tension too low
The animals' hair is wet
Hairs jammed between upper
and lower blades
Too much play in clipper
head
Spacing between upper and
lower clipper blades incorrec-
tly adjusted
Shear stress is too high
Run cutters and / or dry shea-
ring head
Page 9
Have upper and lower blades
resharpened by service
centre
Oil clipper blades every 10
minutes
Increase pressure by tigh-
tening the pressure tension
nut screw
Only clip when dry
Disassemble blades, clean
well and oil; then refit and
increase pressure
Have clipper head inspected
Adjust spacing correctly
Reduce razor voltage
Oils the cutters and head
EN