Caution - Alpine TUA-T550HD Mode D'emploi

DO NOT USE BOLTS OR NUTS IN THE BRAKE OR
STEERING SYSTEMS TO MAKE GROUND CONNECTIONS.
Bolts or nuts used for the brake or steering systems
(or any other safety-related system), or tanks
should NEVER be used for installations or ground
connections. Using such parts could disable control of
the vehicle and cause fire etc.
DO NOT ALLOW CABLES TO BECOME ENTANGLED IN
SURROUNDING OBJECTS.
in compliance with the manual to prevent obstructions
when driving. Cables or wiring that obstruct or hang up
on places such as the steering wheel, gear lever, brake
pedals, etc. can be extremely hazardous.
MAKE THE CORRECT CONNECTIONS.
the proper connections may result in fire or product
damage.

CAUTION

This symbol means important instructions. Failure
to heed them can result in injuryor material property
damage.
HALT USE IMMEDIATELY IF A PROBLEM APPEARS.
Failure to do so may cause personal injury or damage to
the product. Return it to your authorized Alpine dealer
or the nearest Alpine Service Center for repairing.
USE SPECIFIED ACCESSORY PARTS AND INSTALL
THEM SECURELY.
Be sure to use only thespecified
accessory parts. Use of other than designated parts may
damage this unit internally or may not securely install
the unit in place. This may cause parts to become loose
resulting in hazards or product failure.
E -2
n
Arrange wiring and cables
Failure to make
DO NOT INSTALL IN LOCATIONS WITH HIGH MOISTURE
OR DUST.
Avoid installing the unitin locations with high
incidence of moisture or dust. Moisture or dust that
penetrates into this unit may result in product failure.
HAVE THE WIRING AND INSTALLATION DONE BY
EXPERTS.
The wiring and installation of this unit
requires special technical skill and experience. To
ensure safety, always contact the dealer where you
purchased this product to have the work done.
ARRANGE THE WIRING SO IT IS NOT CRIMPED OR
PINCHED BY A SHARP METAL EDGE.
and wiring away from moving parts (like the seat rails)
or sharp or point ededges. This will prevent crimping
and damage to the wiring. If wiring passes through
a hole in metal, use a rubber grommet to prevent the
wire's insulation from being cut by the metal edge of
the hole.
IMPORTANT.
Please record the serial number of your unit
in the space provided below and keep it as a
permanentrecord. The serial number plate is located
on the bottom of the unit.
SERIAL NUMBER: ______________________________________
INSTALLATION DATE: __________________________________
INSTALLATION TECHNICIAN: ___________________________
PLACE OF PURCHASE: ________________________________
Route the cables