Broil Chef 066995000 Guide De L'utilisateur page 17

Sudden drop in gas flow or reduced
flame height.
Irregular flame pattern, flame does not
run the full length of burner.
Flame is yellow or orange.
Flame blow out.
Flare-up.
Flashback [fire in burner tubes].
Persistent grease fire.
Flash back (Fire in burner tube)
Inside of lid is peeling – like
paint peeling.
Irregular flame.
GPC2700JD
Instruction Manual
Guide d'utilisation
Excess flow safety device may have
been activated
Burner ports are clogged or blocked.
New burner may have residual
manufacturing oils.
Spider webs or insect nests in
venturi.
Food residue, grease or seasoning
salt on burner.
Poor alignment of valve to burner
venturi.
High or gusting winds.
Low on propane gas.
Excess flow valve tripped.
Grease buildup.
Excessive fat in meat.
Excessive cooking temperature.
Grease trapped by food buildup
around burner system.
Burner and /or burner tubes are
locked
.
Baked on grease buildup has turned to
carbon.
Air flow is not correct. Correct
Flame blue with yellow tips, 1-2"
high. Too little air: wavy yellow or
orange flames. Too much air:
noise blue flames.
17
Refer to the Excessive flow safety
valve reset procedure on page 15.
Clean burner ports.
Burn grill for 15 minutes with the lid
closed.
Clean venturi.
Clean burner.
Assure burner venturi is properly
engaged with valve.
Turn front of grill to face wind or
Increase flame height.
Replace or refill propane tank.
Refer to the Excessive flow safety valve
reset procedure on page 15.
Clean grill.
Trim fat from meat before grilling
Adjust (lower) temperature accordingly.
Turn knobs to OFF. Turn gas OFF at
propane tank. Leave lid in closed position
and let fire burn out. After grill cools, remove
and clean all parts.
Clean burner and/or burner tube(s).
Baked on grease buildup has turned to
carbon and is flaking off. Clean thoroughly.
If flames are yellow or orange – open
flap at the end of the venturi tubes in
1/8 in. increments until flames are
correct.
If flames are blue and noisy – close flap
at the end of the venturi tubes in
1/8 in. increments until flames are
correct.
*Propane Models must be open a
minimum of 1/8 in.
.