Five Options Of Frost Protection - patura 130.8521 Instructions De Montage

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

1. Heating element 24 V, for installation into the trough

(see separate mounting instructions)

Heating element 24 V, 180 W (131.6063) for installation into the trough.

131.6063

2. Heating element 24 V, for installation under the trough

(see separate mounting instructions)

Heating element 24 V (131.6060, 131.6061, 131.6062, 131.6062 + 131.6088) for installation under the trough. For power supply a SUEVIA Trans-

former 230/24 V is necessary. For automatic switch on/off of transformer a thermostat (101.0389) can be additionally installed. To ensure a frost-free

feed pipe, a frost protection heating cable 24 V, 20 W, 2 m (101.0861), or a 24 V, 30 W, 3 m (101.1863) has to be used. The heating cable should

be wrapped around the pipe and connected to the heating element of the drinker in parallel to the power supply cable, coming from the transformer.

If this heating cable is installed on plastic pipes, make sure that this water pipe is suited for warm and cold water. For better heat distribution the

water pipe has to be wrapped first with an aluminium adhesive tape (101.1099). The frost protection heating cable and the supply line should be

protected against animal bites or other damages.

3. Connection to a water circuit with a circuit pipe

¾" circuit pipe (131.0591) or 1" circuit pipe (131.6122, 131.6123, 131.6124, 131.6125) suited for installation into all flat tip-over troughs. Frost

protection is reached for the water line as well as for the water in the trough, if connected to a water circuit with a SUEVIA heating unit.

131.0591

19.11.2018 · Technische Änderungen vorbehalten · Technical data can be changed without prior notice · Des changements techniques reservés · Мы оставляем за собой право на технические изменения и

дополнения, а также возможные опечатки. · 1048152