Tornado Pac-Vac 6 Roam Mode D'emploi page 10

CHANGING HEPA FILTER ASSEMBLY
To change the HEPA filter:
1. Remove the lid, paper bag and cloth bag to expose the HEPA filter.
2. Remove the filter cap on the top of the HEPA filter (Fig. 18)
3. Remove the HEPA filter from the dust compartment
4. Insert a new HEPA filter and replace the filter cap (Fig. 19). Refit the cloth bag, paper bag, and replace
lid.
Note: The HEPA filter can NOT be washed and reused.
Fig. 18
MAINTENANCE
Clean the cloth vacuum bag regularly. After emptying the vacuum bag, turn it inside out and shake as much
dust out of the fabric as possible. Optimum performance is achieved by using a paper filter bag with the cloth
bag.
Clean the vacuum bag and HEPA filter or free any blockage and ensure that adequate airflow is restored.
Use only approved Tornado paper filter bags.
Ensure the vacuum hose, the extension wand and the vacuuming accessories are not blocked.
Have your unit serviced by an authorized repair service center if you suspect any potential problems.
Ensure that the flexible vacuum bag ring provides a proper seal before vacuuming.
Recommended replacement parts:
C352-2500
B352-2400
B352-2401
C352-1400
X1208
X1200
X1194
Fig. 19
Paper Bag (10 pack)
Motor Exhaust Micro Filter
HEPA Filter
Shake Out Bag
Motor
Battery
Battery Charger w/Cord
10