Wolpertech 04015 Traduction Du Mode D'emploi D'origine page 12

Check regularly the extension cables and replace them if
damaged.
Keep the handles dry and with no oil and fat.
Be careful!
Pay attention to what you are doing. Use common sense
when working. Do not use the appliance if you are tired.
Check the appliance for any damage!
Smooth and specified functioning of guards or slightly
damaged parts must carefully be checked before the
appliance is used the next time.
Check whether the rotating parts are working smoothly and
are not being dragged or whether any parts are not
damaged.
All parts must be assembled correctly and satisfy all
conditions to make sure the appliance works smoothly.
Any guards and parts that are damaged must be
professionally repaired or replaced by an authorised
specialised shop unless provided otherwise in the
Operating Instructions.
Have any damaged switches replaced by a customer
service shop. Do not use the appliance if the switch cannot
be switched on and off.
Risk of explosion
Do not work in rooms where there is a risk of explosion.
Maximum pressure must be adhered to.
Compressed air energy must only be used.
Do not use oxygen and other gases.
CAUTION!
Use of other extensions or accessories may cause injuries.
Have your appliance repaired by a professional!
This appliance corresponds to appropriate safety
provisions. Repairs may only be performed by a
professional who uses original spare parts, otherwise the
user will be subject to the risk of injury.
Special safety instructions
CAUTION!
Squeaking pneumatic hose when the quick-acting
coupling is opened.
Hold the pneumatic hose while being released.
Swirl of dust, liquids, dirt particles and sparks during
operation.
Wear a respirator, protective goggles and protective
gloves.
Noise during operation
Wear ear protection
Risk of appliance rebound!
Do not use a pad to specify the nailing depth
Do not start the appliance in open spaces as the
clamps/nails can freely fly off!
Wear protective goggles.
Prevent possible causes of injury! Disconnect the
appliance from the compressed air source for the
following works:
change of the appliance position or characteristics
Keep the switch fuses in a working state before moving
up/down the ladders, scaffoldings, stairs, travelling work
platforms, landings, unstable bases, etc.
Prevent thin workpieces and edge surfaces from breaking
through!
Vibrations may get transposed on the operator when using
the appliance.
Risk of trip! Pay attention to pneumatic hoses laying on
the floor or, better, avoid such a situation.
Do not use the appliance for hard surfaces like
concrete, metal and similar materials.
12
Never use hydrogen, oxygen,
carbon dioxide or any other
gas in bottles as a source of
energy for this appliance as
that could cause an explosion
and subsequently serious
injuries.
When in the working order,
wear the appliance by its
handle only and never with
the pressed trigger. Make
sure you are not perforating
thin material when working
and the appliance is not
slipping on corners and
edges.
Never connect the appliance
with a pneumatic hose the
pressure of which exceeds
150 psi or 10.0 bar.
The hose must be
dimensioned for pressure of
min. 10.3 bar or 150 psi,
however, at least for 150 % of
the maximum pressure in the
system.
The appliance and the feed
hose must be fitted with a
hose coupling so that the
pressure fully leaks when the
connecting hose is
disconnected.
The magazine can only be
filled when the appliance is
connected to the air inlet.
The appliance must never be
used if the fuse, trigger or
springs are missing or if they
cannot be used or are
damaged. The fuse, trigger
and springs must never be
removed.