Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ELPMBP04
PREPARATION
NOTE:
The ELPMBP04 has been designed to be mounted
recessed into a suspended ceiling secured by a
WireVice system.
1.
Determine exact location of extension column (not included)
on suspended ceiling. Mark location on lower (finished)
side of ceiling tile with pencil (See Figure 1).
Be sure to consider the following items when determining
column location:
•
Dimensional offset of display/projector relative to
column (due to mount and/or interface).
•
For Projectors: Any recommended dimensions of
projector relative to target (See installation instructions
included with the projector).
1
Figure 1
2.
Remove affected ceiling tile and any adjacent tiles required
for access.
3.
Press center tip of ceiling tile cutter (M) into finished side of
ceiling tile at marked location. Cut extension column hole
through tile using back and forth hand twisting motion.
4.
Reinstall ceiling tile with extension column hole. Ensure tile
is oriented for proper location of hole.
5.
Install ELPMBP04 assembly (A) on top of ceiling tile so that
end brackets engage primary (1-1/2" (38mm) high) rails of
ceiling framework. (See Figure 2)
Extension
column
support
6
x 4
8
Figure 2
6
5
= 1.5" (38mm)
7
(A)
9
6.
Loosen four wing nuts in upper side of ELPMBP04
assembly (A). (See Figure 2)
7.
Position ELPMBP04 assembly (A) and/or extension column
support (as required) to center support over ceiling tile hole.
(See Figure 2)
8.
Tighten wing nuts (See Figure 2).
9.
OPTIONAL: Mark location of electrical cutout on ceiling tile
with pencil. (See Figure 2)
10. Examine ceiling structure (concrete, steel truss, or wood)
above ELPMBP04 assembly (A) to identify four support
cable anchor locations. Each location should be
approximately 15° outboard of support holes in ELPMBP04
assembly (A) (See Figure 3). Mark locations with pencil.
10
15°
x 4
15°
x 4
(A)
Figure 3
11. Remove ELPMBP04 assembly (A) and ceiling tile.
12. OPTIONAL: Cut electrical box opening in ceiling tile at
marked location. Install UL Listed Raco 560 or equivalent
UL Listed electrical box (not included) to ELPMBP04 (A)
following instructions included with electrical box.
Installation Instructions
x 4
Publicité
Table des Matières
