Preparing The Remote - Sony TA-F501ES Mode D'emploi

Preparing the remote

Pull out the insulating sheet to
allow power to flow from the
battery.
The remote already contains a battery.
Replacing the battery in the
remote
1
Slide out the battery case in the
direction of arrow 2 by pushing the
lock in the direction of arrow 1 and
then remove the battery from the
battery case.
2
Insert a new lithium battery CR2025
with the + side facing up.
A lithium battery CR2025
3
Slide the battery case back in.
Note
If you do not use the remote for a long period of
time, remove the battery to avoid possible damage
from battery leakage and corrosion.
Notes on lithium battery
• Keep the lithium battery out of the reach of
children. Should the battery be swallowed,
immediately consult a doctor.
• Wipe the battery with a dry cloth to assure a good
contact.
• Be sure to observe the correct polarity when
installing the battery.
• Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
Note
Do not expose the remote sensor
sunlight or lighting apparatus. Doing so may cause a
malfunction.
Tip
When the remote can no longer operate the system,
replace the battery with a new one.
WARNING
Battery may explode if you mistreated.
Do not recharge, disassemble or dispose of in fire.
to direct
9 GB