TFA 60.4001.10 Mode D'emploi page 8

TFA_No. 60.4001_Anleit_04_21
Digital bathroom/kitchen clock with timer
B: Sensor buttons timer
B 1: 10 button
B 3: 1 button
C: Housing
C 1: Screw cover
C 3: Suction cup
C 5: Battery compartment
D: Buttons
D 1: TIME button
D 3: DOWN button
5. Getting started
• Remove the protective film from the display.
• Open the screw cover and insert two new AAA 1.5 V batteries, polarity as
illustrated.
• When the unit is switched on, a signal tone sounds and all segments are
briefly displayed.
• The indoor temperature and humidity appear on the display.
• Press and hold the TIME button for three seconds to enter the setting
mode.
• The hour digit flashes.
• Press the UP/CF or DOWN button to adjust the hours.
• Confirm the hours setting by pressing the TIME button.
• The minute digits flash on the display. Set the minutes in the same way.
14
26.04.2021 15:25 Uhr Seite 8
B 2: CLEAR button
C 2: Suspension device
C 4: Build-in stand
D 2: UP/CF button
D 4: RESET button
Digital bathroom/kitchen clock with timer
• Press and hold the UP/CF or DOWN button for fast mode.
• Confirm the setting with the TIME button.
• Press the TIME button briefly to choose 12 HR or 24 HR system. In the 12-
HR system AM (before noon) or PM (after noon) appears on the display.
• Press the UP/CF button to change between °C (Celsius) or °F (Fahrenheit)
as temperature unit.
• Close the screw cover again.
6. Setting of the timer
• Press the 10 button to set the desired time duration in steps of 10 minutes
and the 1 button in steps of 1 minutes (maximum 99 minutes).
• Press and hold the 10 or 1 button for fast mode.
• If no entry is made for 3 seconds, the function is activated and the time
display counts down. The timer symbol flashes.
• The time now appears in the lower left corner of the display.
• The circular progress bar shows the passage of time.
• An alarm will sound when the set minutes expire.
• Press the CLEAR button and the function will stop.
• The time appears again in large format.
7. Care and maintenance
• Clean the instrument with a soft damp cloth. Do not use solvents or scour-
ing agents.
• Remove the batteries if the device will not be used for an extended period
of time.
• Store the device in a dry place.
15