Novy 990030 Mode D'emploi Et D'installation page 28

FOR ALL THE HOODS except the Touch 894-895-896-897-898-899)
4
Cut off the excess part of the flat cable using a snap-off blade knife unto the connector. Only use the flat cable with the
black sheathing.
Attention! Make sure the device is not live!
Attach the flat cable of the kit using the electronics unit of the cooker hood.
5
Attention! The red marked side of the flat cable must be directed at the inside of the control.
Possible connections for each model:
Mini Pure'line (810-811-820-821)
- Flat cable can be led inside through an existing slot on the rear side of the cooker hood.
- Connect the flat cable to the control board. The control board is located behind the service access, which is visible once
the grease filter has been removed from the hood.
Pure'line (6830-6831-6835-6836-6840-6841-6845-6846)
- Flat cable can be led through the existing openings in the top of the hood.
- The service access is behind the bottom plate. Open this and connect the flat cable to the control board.
Flat'line / Head'line 7800 / Karat / Vlakscherm 663-693 / Maxi Pure'line 855-856
- You must make an extra opening in the electronics housing through which the flat cable can be led in order to make a
connection with the cooker hood.
- Use the cable tensioner supplied to secure the flat cable, if necessary.
For connecting all cooker hoods except Touch go to step 18
EN 28