GRE 777590 Manuel D'instructions page 29

6.4 Setting the real time
On standby or running mode, press
Then press the
When setting the time,
6.5 Water temperature setting:
On standby or running mode, press
Note : the heat pump can running only if the water circle/filtration system is running.
6.6 Automatic start/stop the heat pump
To set the time to start the unit
Press to set the time to start the unit, then press
start
5 minutes after the water pump).
Press again to store the new data.
To set the time to stop the unit
Press to set the time to stop running, then press
stop
5 minutes before the water pump).
Press again to store the new data.
6.7 Cancel the automatic start/stop
To cancel the automatic starter
Press , then press
To cancel the automatic stop
Press , then press
Note : If the water filtration system stops before the heat pump, the unit will shut down (security
condition) and the code EE3 or ON advertise on the controller.
It is important to program the heat pump link the time program of the water filtration system.
For restart the heat pump, turn off and turn on the electrical power supply to restart the unit.
, then press
again to store the new data.
and cannot work.
and
, light off and the automatic start is off.
, light off and the automatic stop is off.
or
to adjust the desired water temperature
or
or
- 26 -
to adjust hour/minute.
to adjust the time (set the time for
to adjust the time (set the time for