Battery Installation; Power Supply; Setting The Alarm - König Electronic HAV-CR26BL Mode D'emploi

IMPORTANT: BE SURE TO REMOVE THE FLIP PROTECTION STRIPS FROM THE BOTTOM OF
THE CLOCK BEFORE USING THE CLOCK.
These strips protect the flip mechanism during transportation. Operating the clock without removing
the strips will damage the clock.

1. BATTERY INSTALLATION

Your clock has a battery back-up which will keep the clock running during a power failure. The back-up
power supply uses 4x AA alkaline batteries which will run the clock for about 24 hours without AC
power.
1. Press the battery cover, release button, [13] and open the battery compartment door [14] on the
underside of the unit.
2. Insert 4x AA alkaline batteries inside the battery compartment following the polarity (+/-) markings
shown. DO NOT USE RECHARGEABLE BATTERIES. Rechargeable batteries discharge after
several months and are not suitable to use as back-up power.
3. Replace the battery compartment cover.
2. WHEN TO REPLACE BACK-UP BATTERIES?
To test the power in the back-up batteries, unplug the AC/DC adapter to initiate battery back-up. If the
radio sound is weak or distorted, replace batteries. If the flip clock slows down and shows another time
than the time displayed on the digital clock LCD, replace the batteries. Note: the night light function will
not work and the "alarm to radio" function will automatically change to "alarm to buzzer" when the AC
power is absent.

3. POWER SUPPLY

The clock operates via an AC/DC adapter. Plug the DC jack of the AC/DC adapter into the DC power
in jack [10] on the rear of the product and connect to your AC supply.
4. SETTING AND SYNCHRONIZING THE TIME
1. Both the flip clock [B] and the digital clock [A] are driven by a built-in, electronic quartz clock.
Setting the flip clock [B] requires synchronizing the flip display with the time shown on the LCD.
2. To set the digital clock [A], press and hold the time key [5] for 3 seconds. The hour digits will flash.
Adjust hour by pressing ◄► the tuning key [1]. Press time key [5] to set hour. Adjust minutes by
pressing ◄► the tuning key [1]. Press time key [5] to set and start the clock.
3. To set the flip clock, use the flip display adjustment wheel [15] on the back of the unit to match the
time on the flip clock display with the digital clock. Only turn the flip display adjustment wheel
[15] in the direction indicated. Turning the wheel in the reverse direction will permanently
damage the clock mechanism.

5. SETTING THE ALARM

1. Press and hold the alarm key [6] for 3 seconds until the LCD display shows "alarm" in its upper left
corner and the hour digits are flashing. Adjust hour by pressing ◄► the tuning key [1]. Press alarm
3