C CO
SAFE safety hose
2
Connection of the CO2 SAFE safety hose to the pressure regulator.
Unscrew the locking nut of the hose connection. Cut the necessary length from the CO2
SAFE special hose. Guide the locking nut over the hose. Push the CO2 SAFE special hose
until it hits the hose connection of the pressure regulator and tighten the locking nut again.
Assembly of the CO2 diffuser
Please see all other assembly steps in the respective assembly and operating
instructions of the CO2 system you are using or the respective CO2 accessory
you are using.
6.
Start-up
D1 CO
pressure regulator, disposable bottles (Art. No. 6063040)
2
After all components are installed, the CO2 supply can be opened on the adjustment knob
of the pressure regulator. Turn direction clockwise.
D2 CO
pressure regulator, returnable bottles (Art. No. 6063050)
2
After all components are installed, the CO2 supply can be opened on the main valve of
the pressure regulator. Turn direction counter clockwise.
The CO2 supply is opened on the adjustment knob of the pressure regulator (turn direction
clockwise) until the manometer for the system pressure gauge F displays the necessary
pressure for your CO2 system.
E CO
fine control valve
2
Open the fine control valve D on the pressure regulator until bubbles rise in the diffuser. It
makes sense to adjust the amount of bubbles to a low amount in the beginning. The amount
can be increased after several hours until the desired CO2 content has been achieved.
19