KREBS Tex-2 Instructions D'emploi page 9

Instructions for removing stains
Preparation
• Do not operate the spray gun without fluid.
• Fill liquid into cup on spray gun and start up gun by pressing switch.
• Make sure that seen from the rear the adjusting screw is turned counterclockwise. This
yields the highest pressure. Turn screw to the right if you desire less fluid or less jet
pressure.
• By turning lever on variable nozzle you can adjust infinitely any given type of jet. F or an
extremely hard, sharp jet the lever points upwards; for a misty, very soft jet it points
downwards.
Removal of stains
With the KREBS stain removal system the dirt is flushed or "shot" through the material.
The back of the fabric to be cleaned must therefore be free, or it must consist of an
absorbant support.
IMPORTANT!
With every new fabric make a cleaning test in an area where no visible damage can be
done.
Perform work quickly. Change over promptly from sharp to soft jet. The quicker the work
is done and the less fluid used, the less is also the danger of forming rings.
Nozzle handle upwards
Flushing with sharp jet.
Nozzle handle downwards
Mist treatment with soft jet.
Appearance of fabric after
flushing with sharp jet.
Appareance after mist treatment
with soft jet.
9