KREBS Tex-2 Instructions D'emploi page 10

With sensitive fabrics dry immediately after mist treatment by shaking cleaned fabric up and
down. If dirt residues are still visible after drying, repeat entire cleaning procedure. It is better
to clean twice quickly with little fluid than to clean once slowly with a lot of fluid.
Operating instructions for Tex-2 device
IMPORTANT
These Operating and Maintenance Instructions are for your information but are not binding.
The differing characteristics of the various types of woven and knitted materials may make it
necessary, in individual cases, to carry out a test on a remnant or on a hidden part of an
article of clothing.
Correct use of the VARIA Nozzle
Select type and force of jet using the lever on the VARIA Nozzle. The pressure of the jet
should be set to match the resistance to displacement of the soiled woven and knitted
fabrics. The stain remover should never be brought so close to the material, that the fabric is
damaged or displaced.
The stain remover has to be directed smoothly and with accuracy, to avoid unnecessary
wetting of the fabric. For large soiled areas it must be guided in a circular motion, so that the
pressure jet rinses the substance from the outside to the inside.
After the stain has been treated the VARIA Nozzle is set to produce a soft, fine mist spray .
This is to avoid the formation of ring marks. Using this mist spray a circular and uniform
transition from the damp to the dry part of the fabric is produced. The damp patch should
appear without contours - that is, without a visible transition. Rapid working will avoid ring
marks becomig fixed in the material.
After completing treatment the damp back -up layer is to be removed. If the work is being
carried out on a ironing board or exhaust table the damp fabric is to be removed from the
wet patch and transferred to the dry part of the working surface. This avoids the transfer of
dissolved staining substances back into the treated material.
If you have to dismantle the VARIA Nozzle for any reason, e.g. if the nozzle head is clogged,
then refer to the operation instructions. Below is an exploded view of the individual part. Do
not use excessive force.
Dismantling the VARIA Nozzle
1. Remove the setscrew 21
2. Pull off the nozzle sleeve 22
3. Push the fitting spanner 31 onto the splined nozzle head 24. Hold the threaded holder
28 by means of a spanner and unscrew the nozzle head.
4. Clean nozzle head and swirl head 29.
10