Fit The Bark Control Collar - Guardian Spray Bark Control Collar Manuel D'utilisation

Fit the Bark Control Collar

Important: The proper fit and placement of your Bark Control Collar
is important for effective operation.
To assure a proper fit, please follow these steps:
1. Make sure that the Bark Control Collar is turned off.
. Start with your dog standing comfortably.
. Place the Bark Control Collar high on your dog's neck
close to the ears. Center the Sensor Probe underneath
your dog's neck, touching the skin. Make sure the
Guardian logo in the front of the unit is upright. Note: It is sometimes necessary
®
to trim the hair around the Sensor Probe to make sure that contact is consistent.
4. Check the tightness of the Bark Control Collar
by inserting one finger between the collar and
the back of the dog's neck. The fit should be
snug but not constricting.
5. Allow your dog to wear the collar for
several minutes, then recheck the fit.
Check the fit again as your dog becomes
more comfortable with the Bark Control
Collar.
6. Trim the collar as follows:
a. Mark the desired length of the collar
with a pen. Allow for growth if your
dog is young or grows a thick winter
coat.
b. Remove the Bark Control Collar from
your dog and cut off excess.
c. Before placing the Bark Control
Collar back onto your dog, seal the
edge of the cut collar by applying a
flame along the frayed edge.
Important: The Bark Control Collar should not be worn for more than 8
hours out of every 24-hour period.
www.guardianpet.net
YES
NO
5