FINO JETSTEAM 52051 Mode D'emploi page 5

Version 1/2013. Read the User Manual prior to commencing work!
TABLE OF CONTENTS
1. Field of application
2. Safety precautions
• Marking of informations • For your own safety
3. Commencement of operation
• Before commencement of operation • Place of installation
4. Operation
• Filling the water tank
5. Maintenance and cleaning
• Replacement of unit fuse
6. Storage
7. Technical data
8. Availability
• Accessories
9. Guarantee
10. Troubleshooting
11. Disposal
• Registration number
Important!
2
1. Field of application
The FINO JETSTEAM Steam Cleaner is suitable for
the cleaning of all objects like e.g. models, metal
frames, dies and instruments. The unit has a tank
with a volume of 3 litres. It operates with 4,5 bars
steam pressure. The high-quality stainless steel
housing is dirt-repellent and can easily be cleaned.
The efficient heating makes the unit ready-to-use
after only 20 minutes heating time. An acoustic
signal as well as a warning light indicates that the
minimum water level has been reached and the unit
switches off automatically. The refilling of water is
done easily and without measuring with the included
filling bottle. The steam pressure of the FINO
3
JETSTEAM can easily and precisely be adjusted.
3
2. Safety precautions
2.1 Marking of information
4
Before you start operating the unit
it is positively necessary to read
4
the user information carefully and
to store it closely at hand.
5
This symbol marks safety informa-
5
tion, whose non-observance may
cause hazards for the unit and its
5
function.
5
This symbol marks safety informa-
5
tion whose non-observance may
cause hazards to persons.
5
6
6
ENU
2.2 For your own safety
Caution! In case of non-observance of these
safety precautions there is the risk of severe
burns and other severe injuries for the operator as
well as for persons in the surrounding! Read the
safety precautions carefully before you start opera-
ting the unit. Store the user information easily
accessible close to the unit. Make sure that children
do not come near the unit. The operator is obliged to
check the unit self-responsible before operation for
reliability.
This includes in particular the checking of
• the power cable for jamming,
formation of breaks or ageing
• the non-leakage of the water drain
screw on the back of the unit
• the integrity and the proper seat
of the water filler
• the steam gun as well as the steam
switches for damages of the insulation
• the steam hose for jamming, cuts or
other damages
• the general outside condition.
Should you find damages of this or other kind
stop operating the unit, make sure that the
unit cannot be put into operation and send the
unit for service to an authorised expert or to
FINO.
Never open the water filler or the water drain screw
while the unit is in operation or the pressure gauge
is not in the zero position. Make sure that the water
filler is always tightly closed before the unit is put
into operation. Do not fill the unit with chemicals or
other additives except for the ones authorised by the
manufacturer. Use only distilled water. Always use
the filling bottle for refilling the water tank. Never
clean units respectively areas, which are under,
power. Never cover the air vents of the unit. Do
never aim the steam gun at persons or animals. The
unit can heat up after longer use. Caution - risk of
scalding. Never touch the nozzle of the steam gun
when the unit is ready-to-operate. Do not operate
the unit with moist or wet hands. Always place the
steam gun in the provided support.
3