Stadler Form Roger Mode D'emploi page 7

• Do not pull the plug from the socket with wet hands or by holding on to
the power cord.
• Do not use the appliance in immediate vicinity of a bath tub, a shower or a
swimming pool (observe a minimum distance of 3 m). Place the appliance
such that a person in the bath tub cannot touch the appliance.
• Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• See to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
• The appliance is not splash-proof.
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• If the power cord is damaged, it must be replaced by the manufacturer
or a repair shop authorized by the manufacturer or by similarly qualified
persons in order to avoid a hazard.
• Prior to any maintenance, cleaning and after each use, switch off the ap-
pliance and unplug the mains cable from the socket.
Filter description
Prefilter (2) The prefilter removes coarse dust particles and dirt from the
air. This protects the following filter from heavy contamination and thus
optimizes its functionality. The prefilter must be cleaned regularly with a
vacuum cleaner once per month and rinsed under running water. Allow the
prefilter to dry completely before replacing it.
: HEPA, Activated Carbon (3) The Dual Filter
Dual Filter
TM
of the air purifier. The material for this filter is produced in Germany espe-
cially for Stadler Form. The Dual Filter
Activated Carbon filter.
The HEPA filter part of the Dual Filter
as fine dust, pollen, viruses and bacteria.
The Activated Carbon filter absorbs gases present in the air (bad odors, to-
bacco smoke, formaldehyde, toluene, volatile organic compounds, etc.) and
filters them out of the air. The capacity of the Dual Filter
means that it must be replaced every 8–12 months, depending on its expo-
sure to air and gases. Should you notice before eight months has passed that
bad odors are no longer being eliminated, this is an indication that the filter
needs to be changed.
Setting up / operation
1. Release the front cover (1) by pulling it forwards by the side indenta-
tions near the top. The prefilter (2) can be removed by pressing down the
two latches at the top. Pull the Dual Filter
remove the plastic film. Set the Dual Filter
textile tabs are visible on the front side. Arrows on the top of the filter (3)
indicate the direction in which the filter must be inserted. Refit the pre-
filter (2) by inserting the positioning aids near the bottom of the prefilter
(2) into the notches on the housing (4) and pressing on the latches until
is a combination of HEPA filter and
TM
filters pollutants out of the air, such
TM
(3) from its housing (4) and
TM
(3) in place so that the two
TM
is the heart
TM
is limited, which
TM