Operating The Electrical Adjustment Options; Selecting The Desired Adjustment Option - Handicare DX-REM 48 Manuel D'utilisation

4 Operating the electrical
adjustment options
Not every wheelchair has been equipped
with electric adjustment options. We make a
distinction between four different adjustment
options to the seating system:
• Tilt adjustments
• High/low adjustments
• Backrest adjustments
• Legrest adjustments

4.1 Selecting the desired adjustment option

1. Switch on the controller.
2. Press on the desired adjustment option (E in fi gure 2). The controller will now be in the 'adjustment
options' mode. The LED light on the button indicates what electrical adjustment option is enabled
(1, 2, 3, 4 or 5).
3. Moving the joystick forwards and/or backwards will activate the selected electric adjustment option
(see table 4). Move the joystick forwards or backwards until the desired adjustment option has
been attained.
Tilt adjustment
High/low adjustments
Backrest adjustments
Legrest adjustments
Table 4
4. To return to the 'drive' mode: Press the selected adjustment option button again. The LED light of
the speed button (F in fi gure 2) will light up. You are now to the 'drive' mode again.
Note: If you adjust the seat height by using the high/low option, the speed will be reduced due to
safety reasons.
Move joystick backwards
The entire chair will tilt
backwards
The entire chair will be raised
The backrest will tilt backwards
The legrest angle will increase,
the footplate will be raised

Operating the electrical adjustment options

Figure 3
Move joystick forwards
The entire chair will tilt forwards
The entire chair will be lowered
The backrest will tilt forwards
The legrest angle will decrease,
the footplate will be lowered
| 23