Changing Settings; Setup Mode - Esoteric RZ-1 Mode D'emploi

Changing settings

1
Press and hold the SOURCE button for more than
2 seconds to enter the setup mode.
Hold down
more than 2 sec.
The setup indicator (
display.
< You can also use the SETUP button on the remote control
unit. (This button does not need to be pushed for more than
2 seconds. It will start setup mode immediately.)
2
Press the SOURCE button repeatedly to select an item.
Each time the SOURCE button is pressed, the item changes as
follows:
Speaker balance
BAL >
Level of high frequency sound range
TREBLE >
Level of low frequency sound range
BASS >
Digital filter
DF >
LINE2/PHONO terminal
L-2 >
DIMMER >
Return to the previous display
(Exit setup mode)
< You can also use the SETUP button on the remote control unit.
< If no button is pressed for more than 10 seconds, the setup
mode will be canceled and return to the previous display.
22

Setup Mode

) and setup item appear on the
3
Press the VOL (+/−) buttons to change the setting.
< You can also use the INPUT (
control unit.
See "Available setup items and settings" on the next page for
Individual setting.
Repeat steps and as required.
2 3
4
Press the SOURCE button repeatedly to exit the setup
mode.
< If one of the following buttons is pressed, the setup mode will
be canceled:
Eject button (L/H)
STOP button (H) on the remote control unit
CLEAR button on the remote control unit
< Memorized settings are stored even after the power cord has
been disconnected.
/ ) buttons on the remote