Important Notices - Teuco Seaside 641 Manuel De L'utilisateur

EN

IMPORTANT NOTICES

1) Do not operate the device with amounts of salt
that are not correct for the temperature of use and
the amount of water in the pool; these operating
conditions will trigger an alarm on the control panel.
2) If the pH is very low (pH < 5) or if there is high
chlorine content (values > 900 ORP), replace some
or all of the water in the pool.
3) Never use other chemicals than those stated
here as this could cause damage to the device.
4) If the tub remains empty for a long period,
ensure that the sensors remain immersed in water,
or remove them and keep the extremities humid.
Use the wrapping in which they were originally
supplied and soak the sponge inside the wrapping
as necessary.
5) Never use iodised salt.
6) Never use copper-based products (anti-algae
treatments).
7) For cloudy, whitish water, correct the alkalinity
and then the pH.
8) Corroded accessories or skin irritations: this
means the chlorine concentration is too high
( > 900) and/or the pH is too low (< 6.5). Partially
empty the tank and top up again.
9) Coloured water: dissolved metals; carry out a
hyperchlorination (TREAT in MANUAL) and clean
the filters.
10) Foam: due to the type of device, there is a foam
effect but only while the water is moving (HYDRO
on). If foam is present even when the HYDRO is
switched off, proceed with a partial or total water
replacement to restore optimum water parameters.
11) Please make sure the AWT system is in stand-
by while using the product; otherwise manually set
the system to the OFF position.
AUTOMATIC WATER TREATMENT
6