Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
LIST OF CHEMICALS SUPPLIED WITH THE
AUTOMATIC WATER TREATMENT
a) Quick test tester 63000566000
This contains "STRIPS" for checking basic water
parameters, chlorine, alkalinity and pH.
b) Calcinex 0.5 L 63000548000
This serves to correct alkalinity levels.
c) pH-MInus 6 kg 63000552000
This serves to correct the pH value of the water
and to prepare the acid solution used to top up
the pool.
USING FOR THE FIRST TIME
- Remove the probes from their protective casing.
- Install the probes on the hydraulic device for
automatic water treatment.
- Make the electrical connection for the probes
on the electric panel as marked (ORP and pH) on
the probes; the pH probe connection is blue and
the ORP probe connection is red.
- Fill the pool with water until the it is operating
normally (see the manual for control panel use).
- Keep the probe casings to one side as they may
be useful if the system is going to be left unused
for long periods.
Continuous improvements made to the
product could bring about the availability of
new products/treatments at a date after the
publication of this manual. Periodically check the
availability of new chemical products approved
by Teuco, to take advantage of the relative
benefits.
4
ORP
PH
1
AUTOMATIC WATER TREATMENT
2
ORP
sensor
PH
sensor
Publicité
Chapitres
Table des Matières
