Chloride Power Protection Desk POWER 300VA Guide De L'utilisateur page 23

7 - Assuming that the old batteries are fully charged. Use the same precautions you would use when
handling a new battery. Do not short battery terminals with a cable or tool! Batteries contain lead.
Many areas have regulations about disposing of used batteries. Please dispose of old batteries
properly. Do not dispose of batteries in a fire because the batteries could explode. Do not open or
mutilate batteries. Released electrolyte is harmful to the skin and eyes. It may be toxic.
8 -This equipment may produce ozone. Take precautions to ensure that the concentration of ozone is
limited to a safe value.
Please replace the battery by following these steps:
1. Remove the screw on the bottom side of the UPS and slide the door off.
2. Gently pull out the battery by grasping the tab.
3. Disconnect the two wires connecting the battery to the UPS.
4. Connect the battery wires to the new battery; red to positive (+), black to negative (-). Carefully
place the new battery into the case.
5. Slide the battery door back into place and secure with the screw removed in step1.
6. Install the UPS according to the procedure described in section 3
945014.066 REV: 17/04/01
Operating manual
UK
23