La Cornue Cornuchef Manuel D'installation page 10

min. 750 mm. If the manufacturer of the gas
cooking appliance specifies a greater
distance, this must be taken into consideration.
Gas cookers
Comply with the currently valid installation
regulations and instructions of the gas
appliance manufacturers. The extractor hood
may only be installed over gas hobs at a
minimum distance of 750 mm provided the
following nominal thermal loads (Hs) are not
exceeded:
Gas cookers
Load of one hotplate max.
Load of all hotplates max.
Load of the oven
Gas hobs
Load of one hotplate max.
Load of all hotplates
Installation Instructions
Wall-mounted range hood
Tower Holder
1. (For exhaust air ventilation) Prepare the
appropriate exhaust air channel in the
pertinent wall/ceiling of the installation site.
3.0 kW
8.3 kW
max. 3.9 kW
3.9 kW
max. 11.3 kW
Connetion for
Hose
Wall Fastener
2. Identify the correct locations for the
following attachment holes using the
dimensions stipulated below for reference.
Any dimensions not listed are model specific.
For these, you will have to take
measurements right on the hood. Make sure
you comply with the minimum clearance
between the range and the bottom edge of
the range hood.
2 drill holes (Ø8mm) for hanging the tower
top
2 drill holes (Ø10mm) for mounting and
attaching the range hood
Please make sure that the range hood is
positioned in the center of the range cooking
surfaces.
en