Delta 50-760 Manuel D'utilisation page 11

ATTACHINg THE TOP FILTER BAg
disconnect the machine from the power source!
1. Place a large 5/16" flatwasher on a 5/16" hex head
screw.
2. Position the bracket (A) on the dust collector (Fig.
12).
3. Insert 5/16" hex head screw through the hole in
the bracket, then thread it into the hole in the dust
collector. Tighten securely with a 12mm wrench.
4. Thread the other two screws into the appropriate
holes and tighten securely.
5. Insert the rod into the pocket on the filter bag (A) Fig.
13.
6. Insert the rod in the hole in the bracket (B).
7. Work the open end of the filter bag into the top
groove of the dust collector drum until it is secure
and sealed. Bend and fold, as necessary, the internal
bag retainer ring to fit it into place.
8. Attach the other filter bag in the same manner.
ATTACHINg THE HOSE TO THE INTAKE PORT
disconnect the machine from the power source!
Model 50-760 provides two 4" dust ports. To attach the
hose:
NOTE: Place the open end (D) of the intake cap rings
around and on the ends of each dust intake port before
attaching the hose.
Loosely attach the hose clamp (A) Fig. 14 around one
end of the flexible hose (B). Attach the hose to the dust
intake port (C). Tighten the hose clamp (A). Attach the
remaining clamp to the other end of the flexible hose and
to the woodworking machine.
NOTE: Do not operate the dust collector with any dust
intake port (C) Fig. 13 uncovered. Place the flat intake
cap (E) on the dust intake port (Fig. 14).
A
A
B
d
11 - English
Fig. 13
A
C
B
E
Fig. 14
Fig. 12