Coverage Patterns - LEGRAND Wattstopper DW-100 Instructions D'installation

Table des Matières

Les langues disponibles

Coverage testing has been performed according to the NEMA WD 7 guideline. For best performance, use in spaces not larger than

18' x 15'.

PIR Sensor

The sensor has a two-tiered, multi-cell viewing Fresnel lens with 180 degree field of

view. The red LED on the sensor flashes when the PIR detects motion.

Masking the Lens

Opaque adhesive tape is supplied so that sections of the PIR sensor's view can be

masked. You can eliminate coverage in unwanted areas. Since masking removes

bands of coverage, take this into account when troubleshooting coverage problems.

Ultrasonic Sensor

The sensor has two ultrasonic transceivers operating at 40kHz. Detection sensitivity

can be adjusted using the trimpot under the ON/OFF buttons.

Side View

(1.2m)

1. Make sure that the power has been turned OFF at the circuit breaker.

2. Connect wires to the DW flying leads as shown in the wiring diagram below that is appropriate to the DW

model and electrical supply.

3. Attach the DW to the wall box by inserting screws into the two wide holes on the top and bottom of the

attached metal bracket. Match them up with the holes in the wall box and tighten.

4. Turn the circuit breaker ON. Wait one minute, then push the ON/OFF button for each load and the lights

will turn ON.

5. Test and adjust the sensor if necessary.

6. Attach the cover plate.

DW-100 and DW-100-347 Wiring