INFOSEC UPS SYSTEM Zen-X 600 Notice D'utilisation page 6

L C D s c r e e n
1. Input voltage
2. Output voltage
3. AC mode (UPS in AVR mode, this LCD symbol flashes)
4. Battery mode (when AC input voltage is abnormal, this LCD symbol lights)
5. Battery level (battery capability)
6. Low battery (when battery voltage is low, this LCD symbol flashes)
7. Load level (load percent)
8. Over load (when there is output over loading, this LCD symbol flashes)
9. Fault mode (this LCD symbol light when UPS in fault mode, such as output shorted, over
voltage, overload)
7. INSTALLATION AND OPERATION
1. Checking
When you receive your equipment, open the packaging and check that your UPS has not
been damaged. Packaging includes: UPS unit, input power cord, USB cable and a
multilingual user guide.
2. Charging the batteries
This unit is shipped from the factory with its internal battery fully charged, however, some
charge may be lost during shipping and the battery should be recharged prior to use. Plug
the unit into an appropriate power supply and allow the UPS to charge fully by leaving it
plugged-in, with no load, for at least 6 hours.
The UPS will automatically recharge its own batteries whenever the switch is in the "ON"
position. You may use the UPS immediately, however the back-up power capacity may be
lower than the nominal value required.
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
6
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 07 17 AA 24 205 31
1 - Input voltage
2 - Output voltage
3 - AC mode indicator
4 - Battery mode indicator
5 - Load level indicator
6 - Battery capacity indicator
7 – Fault indicator
– flashing indicates overload
– flashing indicates low battery