Safety Measures - T.I.P. WPF 1500 S Mode D'emploi

The pump must not be used when people or animals are in
the water.
The pump must be supplied through a residual current
device (RCD) having a rated residual operating current not
exceeding 30mA.
The mains power connection of this device cannot be
replaced. In case the line is damaged, the device must be
scrapped.
Disconnect the device from the power supply and let it cool
down before cleaning and maintenance is performed and
before the device is stored.
Particular attention must be paid to notices and instructions with the following symbols:
Danger of injury or material damage if this instruction is not complied with
Danger of electrical shock that can result in injury or material damage if this instruction is
not complied with
Check the device for transport damage. If there is damage the retailer must be notified
without delay, at the latest however, within 8 days of the purchase date.

2. Safety measures

Attention! Use in garden ponds and the protected area of garden ponds is only
permitted if the installation complies with the valid regulations. Consult a qualified
electrician.
Attention! Do not use the pump in or on swimming pools!
Prior to use:
• Check the mains cable and plug for damage.
• Mains voltage and current type must agree with the information on the type plate.
• Only connect the pump via a residual current circuit breaker (RCCB, ∆ = 30 mA) to a
proper earthing contact socket.
• Install the connection socket in the water-protected area and at least 2 m away from
the edge of the pond.
• Always protect the mains plug from moisture.
• Unplug the mains plug before performing any work on the pump, fountain or pond.
• Do not operate the pump if there are people in the water (disconnect the pump from
the mains supply beforehand!)
• Important! If there is damage to the mains cables or the motor housing the complete
pump is unusable and must be disposed of. Repair is not possible because the
connecting cable is permanently cast in the motor housing.
• Never suspend or transport the pump by the mains cable.
2
10