Inserting Batteries; Replacing The Batteries; Installation; Installation Using Screws - brennenstuhl BrematicPRO SmartHome 1294200 Mode D'emploi

Wireless siren 868.3 MHz

Inserting batteries

Battery cover screw
Installation plate Battery cover
Remove the installation plate on the reverse side of the siren.
Remove the battery cover screw using a suitable tool.
Open the battery cover and insert the batteries with correct
polarity.
Now reassemble the device in reverse order. Only place the
installation plate on the device after you have paired the siren
to the Gateway.

Replacing the batteries

Put the siren into "Service mode / Replacing the battery". To do
so, select "Rooms" in the app settings. Select the room in which
the siren is installed, then select the siren. In the submenu,
activate the checkbox for "Service mode/Replacing the battery",
otherwise the sabotage switch will trigger an alarm.
ATTENTION: If a task is set with the trigger "Siren sabotage",
this will be run when the siren is opened.
Replace the batteries.
Remove the tick under "Service mode / Replacing the battery"
so that the siren is activated again.

Installation

Note: Carry out the siren pairing process with the BrematicPRO
Gateway before beginning installation.
Note: Check before installation whether the product is located within
the range of the Gateway.
Put the siren into "Service mode/Replacing the battery" so that the
alarm is not accidentally triggered during installation.
12 EN
3 x 1.5 V LR14 / C Battery

Installation using screws

CAUTION! DANGER OF ELECTRIC SHOCK! Make sure that
you do not damage electrical cables in the wall during installation.
An eaves, for example, is particularly suitable for outdoor
installation.
Remove the installation plate from the device.
Open the mounting holes with a sharp object.
Mount the installation plate with the UP symbol pointing
upwards.
Draw the three drill holes on the wall using a pen, with the help
of the installation plate.
Ensure that the arrow on the rating plate / the installation plate
is pointing upwards.
Drill the marked holes using a suitable drill and insert the dowels.
Screw the installation plate to the wall using the screws provided.
Note: When installing on a wood surface, use a 1.5-2 mm drill.
You will not require any dowels.
Place the device on the installation plate and press the siren
down firmly until it audibly clicks into place in the notches.

Download app / PC software BrematicPRO

The Brennenstuhl Home Automation System BrematicPRO is controlled
via the BrematicPRO app / PC software. The app can be downloaded
for free from the App Store and Google Play Store. The PC software is
available for download at www.brematic.com/en/service.
For more information about the app and how to use it, please visit
www.brematic.com/en/service.
Pairing the wireless siren with the
BrematicPRO Gateway
The app or BrematicPRO PC software is installed and open.
The BrematicPRO Gateway is ready for use.
Keep the device at least 50 cm from the Gateway.
Open the "Settings" menu.
Select submenu "Rooms," then select the room.
Tap the "Add Device" button.
Select the frequency band "868 MHz".
Select "Siren" and press "Continue" to confirm.
Follow the instructions in the app.
Press and hold the pair button for 3-4 seconds (attention: after
> 6 sec. it is reset) to set the device to pairing mode.