Technical Data; Relevant Models; Technical Specifications; Nameplate - empasa 200x120 Notice De Montage Et D'utilisation

Technical data

Relevant models

These operating instructions refer to the clamping awning model H023:

Technical specifications

Model version A:
Features: Model height (with fully extended awning) 3170 mm
Length of drop-arm 1200 mm Model width 2000 mm
Wind resistance class according to EN 13561 = Wind class 1. Static pressure 40 N/m2
Model version B:
Features Model height (with fully extended awning) 3170 mm
Length of drop-arm 1200 mm Model width 3000 mm and 4000 mm
Wind resistance class according to EN 13561 = Wind class 1. Static pressure 40 N/m2

Nameplate

The CE plates correspond to the specified models according to EN 13561.

Transportation and unpacking

Transportation of the clamping awning
The customer is responsible for the handling and transportation of the clamping awning and must ensure appropriate
transportation without damaging the original packaging. Any product damage caused by disassembly and handling or
transportation after installation is not covered by the warranty. Packaging material must be disposed of and/or recycled in
accordance with the locally regulations in the country of use.
Packaging, handling and removal of packaging
The clamping awning is packed in polythene bags and is protected by cardboard and rubber pads that protect the support
frame and awning fabric during transportation.
NOTE!

Unpacking

The clamping awning must always be positioned with the cloth facing upwards. Fasten the clamping awning firmly around the
clamping arm holders or with additional wrapping. Use scissors with rounded ends to open the packaging to prevent damage
to the cloth.
WARNING!
CAUTION: UNDER NO CIRCUMSTANCES SHOULD YOU USE A SHARP-BLADED CUTTER OR PAPER KNIFE! Keep the
packaging materials out of the reach of children as they may pose a hazard.
47
V2/2020-EM-H023