dirna Bergstrom bycool green line COMPACT 3.0 Instructions De Montage page 18

COMPACT 3.0
EN
8 Place the console using original screws and align
in the Compact in the most ideal position, until
the original screws coincide in their location.
9 Once these operations are complete, dismount
the console, turning the nuts (A) until the EPDM
seal is compressed between 3 and 5 mm
approximately, then turn the nuts at the base of
the Compact (B) and the upper nuts of support
C. Diagram A.
Important: In order to prevent possible filtrations
of water, ensure the seal is tight with the base of
the Compact - Torque 1.3 a 1.8 kg. As indicated
in Diagram A.
Turn nuts "A" to tighten the seal between 3 and 5
mm and then tighten nuts "B" and "C".
10
Mount the console again using the original
screws.
10
18
®