dirna Bergstrom bycool green line COMPACT 3.0 Instructions De Montage page 16

COMPACT 3.0
EN
3
CABIN EXTERIOR:
Position the Compact in the gap.
Caution! When positioning the unit above
the hatch gap, check that the wastewater
run-offs are not blocked by the EPDM seal.
4 CABIN INTERIOR:
4- Thread 5 mm approximately (4) studs
6/100x120 in the base of the Compact.
Position (1) rubber washer Ø 6, (1) wide flanged
Ø 6 flat washer, (2) M6 nut and (1) wide flanged
Ø 6 flat washer, in each one of the previous
studs.
From point 5 up to point 8 the operations carried
out are to align the Compact, which is why there
is no full tightening.
5
Position (2) attachment supports on the studs
between the outer cover and the metallic
structure of the cabin.
6
To place the foam rubber ducting remaining at
the softer part of the base.
6
16
3
Sun hatch
4
4
5
®