Standard Programming; Important - DEA SYSTEM NET230N Notice D'emploi Et Avertissements

6 STANDARD PROGRAMMING

WARNING For reversible motors with electromagnetic brake, remember to set P062=3.
1
Power Supply
Give power supply, the display shows the following symbols "
*
If the control panel has already been programmed and the power fails or is switched off - once power is returned and a START
command is given, the position reset procedure is performed (see "rESP" in the table "WORKING STATUS MESSAGES" on page 35.
2
Visualisation of inputs and operations-counter status
1. Press the key for 15 seconds;
2. The display will show respectively:
Inputs status (check it's correct);
Total operations counter (* see P064):
i.g.: = 3x100* = 3000 operations performed
Maintenance operations-counter (* see P065):
i.g.: = 5*x500 = 2500 operations remaining
before the maintenance intervention request (
manoeuvres-counter disabled)
3. Hold down the key to display a cyclic 3 options, or
release the button to exit the parameter.
3
Selection type of operators
1. Scroll down the parameters with
sualise P028;
2. Access the parameter by pressing the
3. Acting on and keys, set:
Type 00 Type 01
• 005 6NET • 001 Look - Mac • 003 Livi 902EN
• 006 9NET • 002 Ghost • 004 Livi 902R -
• 007 Gulliver • 003 Livi 500 902R/EN/F
- Rev - 502 - 502EN -
550PL
• 004 Livi 500R/
EN - 502R -
502R/EN - 502L
• 005 Oli
Warning: Selecting the OLI operators, all indicated values related
to the operator force (P037 - P038 - P039 - P040), are automati-
cally set to 100% without any possibility of change. For this type of
operator, the obstacle detection is not active and the adjustment of
the thrust force can be executed acting on the operator valves only.
Warning: If you are using non DEA System operators, set the pa-
rameter on the closer value for family type and performances (refer
to table on page 20).
4. Confirm your choice by pressing the
again to P028).
=

! IMPORTANT !

and keys until you vi-
key;
Type 02 Type 03 Type 04
• 003 Pass • 000 Lato
• 004 Stop
key (display returns
", " ", " " (or the Type selected) and then "----".
25