Whirlpool WED4850HW Manuel D'instructions page 25

10. Add inside door panel back into the dryer door by sliding the
top into the top trim piece and then lower door down. Then
press down on the corners to snap into place with the hinges
lined up with the hinge holes.
11. Install 6 hinge screws and the other 4 screws.
12. Install hinge covers and plugs. Hinge covers will go inside
ways to then rotate 90° and snap into place.
13. Hang door by placing set pin in dryer cabinet hole and slide
door down. Using a T20
then (B) screws. Tighten all hinge screws.
screwdriver, install (A) screws and
®
A
B
A
B
25