Manual For Flexismart Controller - ThermoTec AeroFlow MINI 650 Instructions De Montage

Manual AeroFlow®
Status-Display
12:34
21
°C
.7
15.5°C
Temperature-Overview
21.7°C
15
°C
.5
OK
Programs
12
The first menu you will see after switching your AeroFlow® your heater will show the current time on the
top left (for setting see page 15). The large temperature next to the thermometer icon shows the current
room temperature. The small temperature in the lower right corner shows the target temperature.
Depending on the program setting, the following icons are visible:
= Manual mode (program mode Off). The target temperature will be controlled via the arrow buttons.
= The AeroFlow® heater is in program mode (see page 12/13).
= The heater is heating. As soon as the heating elements switch off, this symbol disappears.
= Open window detected, the AeroFlow® heater is temporarily switched off.
= Holiday Mode: The digit below the icon indicates the number of remaining holidays (see page 14).
= Keylock/Childlock ON (to enable/disable press both arrow buttons simultaneously for min. 5 sec.).
NOTES:
If the clock symbol (program mode) is not displayed, lower or raise the target temperature by using the
arrow buttons. The AeroFlow® heater will always hold this temperature.
In case the program mode is enabled (the clock symbol is displayed), the target temperature can also be
lowered and raised with the arrow buttons. The manually set target temperature overrides the program
mode until the next preset start or end time of a time frame. The AeroFlow® heater returns to
programming mode after then.
To turn the heater off, keep the OK button pressed for at least 5 seconds.
"Standby" will be displayed. Power consumption in standby mode below 0.1 watts.
The display view changes after 5 seconds without pressing a button. The current temperature is displayed
on top and the target temperature at bottom.
In this menu you can change or view your heating times.
You don't see this menu item?
Enable the programming mode in the configuration menu by switching "Programs" to "ON".
See
Select this menu if you want to view the heating plan. You can not make
changes in this menu item.
Thursday
Select day
Select the day of the week for which you want to
see the heating plan.
Start End Temp See the heating plan on
00:00 08:00 11,0°C
the choosen day. Press
08:00 16:00 19,0°C
16:00 00:00 11,0°C
OK to exit the menu item
--:-- --:-- -- °C
--:-- --:-- -- °C
display.
--:-- --:-- -- °C