Dcc Installation - Thermolec DCC-12 Manuel D'installation

DCC INSTALLATION

STEP 1: CHECK THE PACKAGE CONTENTS
1 x DCC-12
DCC-12
INSTALLATION MANUAL
MANUEL D'INSTALLATION
Nema 3R Enclosure
Boitier Nema 3R
MODEL MODÈLE
DCC-12
1 x Installation manual
INSTALLATION VIDEO
To access our installation video, visit our website www.dccelectric.com
STEP 2: PREPARATIONS FOR INSTALLATION
1. Disconnect the main power
2. Select the DCC intended location.
Select an intended location preferably less than 25 feet away from
the electric panel (power source). The current transformers sup-
plied have a wiring of 25 feet in length, but can be extended (see the
section Step 4: Conductor connexions for the extension details).
2 x Current transformer (CT)
(with 25 feet of wire)
Demand charge controller
I E N G L I S H I
for electric vehicles
I F R A N ÇA I S I
Contrôleur de charge pour véhicules électriques
MAIN POWER SUPPLY
240/208V, Single Phase
60A - 70A - 80A - 90A - 100A - 125A - 150A - 200A
ALIMENTATION PRINCIPALE
240/208V Monophasé
60A - 70A - 80A - 90A - 100A - 125A - 150A - 200A
APPROVED MARKET
North America
MARCHÉ AGRÉÉ
Amérique du Nord
Read and save these instructions
Lire et garder ces instructions
Manufactured by
Manufacturé par
Designed by
Design par
V1
1
I
The DCC can be mounted:
- on a ceiling
- on a wall
NOTE: The DCC controller must be mounted so that
the nameplate remains visible at all times.
Do not install the DCC:
- In a location with high level of risk.
- Nearby inflammable materials, explosives
or fuels, chemical products and vapors.
3. Before installation, check the DCC mounting position.
Wall installation
Refer to the information on the
enclosure to insure proper installation.
Warranty automatically void if the DCC is installed incorrectly.
STEP 3: INSTALLATION
Ceiling installation
1. Remove the 4 cover screws.
2. Fix the ceiling mounting support on the DCC.
3. Lift the DCC using the ceiling mounting support.
4. Position the DCC at the intended location.
5. Fix the DCC with the anchors for the type of surface.
6. Check that the DCC is adequately fixed to the wall or ceiling.
7. Remove the ceiling mounting support.
Wall installation
1. Remove the 4 cover screws.
2. Position the DCC at the intended location.
6
Ceiling installation
The installation may be
done in any direction.
WARNING I