Cleaning And Maintenance; Technical Specifications - Perel Tools AJUS7 Mode D'emploi

vehicles battery. Make sure the clamp is secured tight.
•
When the jump starter beeps and the red connection status LED [7] lights up the clamps are
connected with the wrong polarity. DO NOT switch on the current under this condition as this will
cause serious and irreversible damage to the vehicle. Reconnect the clamps with the right polarity
and make sure the green status LED [7] lights up before proceeding.
•
Turn the current switch [7] clockwise (ON).
•
Try to start the vehicle for 3 to 5 seconds. If it does not start, try again for 3 to 5 seconds.
•
After 2 attempts, stop trying and wait at least 10 minutes for the jump starter to recuperate.
•
When the engine starts, turn the current switch [7] anticlockwise.
•
Disconnect the jump starter from the battery, starting with the clamp on the negative pole (black)
and than proceed with the clamp on the positive pole (red).
•
Return the current cables to their stored position to prevent accidental touching.
•
Recharge the starter as soon as possible.
USB port
•
The USB port [4] provides a 5 Vdc 500mA output.
•
Plug in a suitable USB device (not incl.) into the USB port [4] and press the USB button [1]. The
battery level LEDs turn on to indicate the remaining battery level.
•
Note: make sure the specifications of the USB device match these of the USB port.
•
When finished using the USB port [4], press the USB button to switch off the USB output.
7.

Cleaning and Maintenance

•
Switch the jump starter off and remove all connections.
•
Clean the housing with a slightly damp cloth. Wipe off with a soft cloth.
•
Do not use detergents or abrasive cleaning products. Avoid using cleaners based on benzene,
trichloroethylene, chloride, ammonia... as they affect or even dissolve plastic parts.
Disposal
The device contains a sealed lead-acid battery and needs to be recycled like any other battery. Follow
local regulations for proper disposal.
8.

Technical Specifications

internal battery
output
charging
weight
dimensions
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulting from (incorrect) use of this device.
For more info concerning this product and the latest version of this manual, please visit our
website www.perel.eu.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part
of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 02 – 07/01/2014
rechargeable, 12V 7Ah sealed lead-acid battery
1x: 12VDC (cigar lighter receptacle) > max. current 15A
1x: 5VDC (USB connector) > max. current 500mA
2x: start cable with crocodile clamp (+ and - ), 12V 250A cranking current,
peak current 500A
trough included mains adapter or cigar lighter plug
3900g
290 x 185 x 190mm
AJUS7
5 ©Velleman nv