Jump Starting - Perel Tools AJUS7 Mode D'emploi

•
Warranty is limited to the device itself; damage to connected devices and/or machines is the sole
responsibility of the user.
•
Keep this manual for future reference.
4. Features
•
jump starter with a crank capacity of 250A (peak current 500A)
•
for jump-starting cars, motorcycles and other engine powered devices with a 12V battery
•
12Vdc energy station
•
5V USB output for charging/powering navigators, mp3-players, mobile phones etc.
•
automatic overload protection
•
reverse 'hook-up' indication to prevent damage when jump starter polarity is reversed
•
battery level and charging indicator
•
very compact, easy to transport
•
contemporary look and easy to use
5. Overview
Refer to the illustrations on page 2 of this manual.
1
USB and status button
2
battery level
3 cigar lighter socket
4 USB output
5 charging LEDs
6. Operation
Warning
Always check the condition of the cables and clamps before using the jump starter.
Do not use if the cables and clamps show any damage.
Warning
The AJUS7 jump starter is designed to jump start machines with a 12Vdc lead-acid battery;
maximum current is 500A.
Verify that the use of this device is not prohibited by the manufacturer of your car. DO NOT
use it when this is the case.
Refer to the illustrations on page 2 of this manual.
Charging
•
The internal battery must be fully charged before first use. It must also be recharged after each use
and at least once every month to ensure its availability.
•
Plug the output plug of the included adaptor into the adaptor input [6] and plug the other end into a
suitable mains outlet (230 Vac / 50Hz).
•
The red charging LED [5] lights up during charging; when the battery is fully charged, the green LED
[5] lights up. Unplug the power adaptor when charging is completed.
•
Note: it is also possible to charge the battery via the cigar lighter socket. Plug one end of the
included cable into the lighter socket [3] and the other end into a suitable outlet (max. 13.8 Vdc).
•
To see the battery level at any time, press the status button [1]; the battery level is indicated by 3
LEDs [2].

Jump starting

•
Remove all connections from the cigar lighter socket [3], USB port [4] or adaptor socket [6].
•
Turn the current switch [7] anticlockwise.
•
Turn off the ignition of the vehicle before making any connections.
•
Connect the positive (red) clamp [8] of the jump starter with the positive pole (+) of the vehicles
battery. Make sure the clamp is secured tight.
•
Connect the negative (black) clamp [9] of the battery charger with the negative pole (-) of the
V. 02 – 07/01/2014
AJUS7
6
adaptor input
7
connection status + current switch
8 positive clamp
9 negative clamp
4 ©Velleman nv