Installing The Battery; Charging The Battery; Installing The Memory Card; Turning The Phone On And Off - Wiko Darknight Hell Guide Rapide

Installing the Battery

~
Note : only use batteries, chargers and accessories
approved by WIkO.
Put the battery into its slot by aligning the phone and
battery contacts, then press lightly on the battery to
fit it into place.

Charging the Battery

~
Your phone is powered by a rechargeable battery.
The status light changes colour to indicate the
charging level of the phone. Connect the charger to
a power outlet and the micro UsB connector to the
phone's UsB port.
For more information, refer to the Safety Informa-
tion section.

Installing the Memory Card

~
Your phone takes a MicrosD memory card of up to
32GB.
To install a memory card, turn the phone off then re-
move the back cover and take the battery out. Now
insert the memory card in the slot.

Turning the Phone On and Off

~
To turn the phone on, press and hold the ON/OFF
button.
If your sIM card is locked, you must enter the correct
PIN code to unblock the sIM card when the phone is
powered up. Your PIN is supplied by your operator;
if you did not receive it or have lost it, please contact
them.
When the PIN is entered incorrectly three times, the
mobile phone is blocked and has to be unblocked
using your PUk (this is supplied with the sIM card;
if this is not the case, you should contact your phone
operator).
To turn the phone off, press and hold the ON/OFF but-
ton until the menu opens, then press on switch Off.
Now press Ok to confirm.
The phone vibrates when it is shut down completely.