Safety Instructions; Electrical Connection - Leonard LK0843 Notice D'utilisation

16 Leonard
Do not use mechanical devices or other means to accelerate
•
the defrosting process, other than those recommended by
the manufacturer.
Do not damage the refrigerant circuit.
•
Do not use electrical appliances inside the food storage
•
compartments of the appliance, unless they are of the type
recommended by the manufacturer.
Do not use water spray and steam to clean the appliance.
•
Clean the appliance with a moist soft cloth. Only use neutral
•
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.
Do not store explosive substances such as aerosol cans
•
with a flammable propellant in this appliance.
If the supply cord is damaged, it must be replaced by the
•
manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.

SAFETY INSTRUCTIONS

Installation
WARNING! Only a qualified
person must install this
appliance.
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Obey the installation instruction supplied
with the appliance.
• Always be careful when you move the
appliance because it is heavy. Always
wear safety gloves.
• Make sure the air can circulate around
the appliance.
• Wait at least 4 hours before connecting
the appliance to the power supply. This
is to allow the oil to flow back in the
compressor.
• Do not install the appliance close to
radiators or cookers, oven or hobs.
• The rear of the appliance must stand
against the wall.
• Do not install the appliance where there
is direct sunlight.
All manuals and user guides at all-guides.com
• Do not install this appliance in areas that
• When you move the appliance, lift it by

Electrical connection

• The appliance must be earthed.
• All electrical connections should be
• Make sure that the electrical information
• Always use a correctly installed
• Do not use multi-plug adapters and
are too humid or too colds, such as the
construction appendices, garages or
wine cellars.
the front edge to avoid scratching the
floor.
WARNING!
WARNING! Risk of fire and
electrical shock.
made by a qualified person.
on the rating plate agrees with the
power supply. If not, contact an
electrician.
shockproof socket.
extension cables.