Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
applications of the tool. However if the tool is used for
different applications, with different acces sories or poorly
maintained, the vibration emission may differ. This may
significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should
also take into account the times when the tool is switched
off or when it is running but not actually doing the job. This
may significantly reduce the exposure level over the total
working period.
Identify additional safety measures to protect the operator
from the effects of vibration include: main taining the tool
and the accessories, keeping hands warm, organisation of
work patterns.
3.0 Maintenance
3.1 Additional weight (D)
► Only the original weight may be used. Never use other
weights or add additional weights as these can cause
the machine to become overloaded!
► WOLFF recommends that no more than 2 additional
weights are used.
► Only WOLFF weights may be used. Fit additional
weight (2) at an angle and engage
3.2 Mounting segments (C)
► Information on quick exchange of grinding seg -
ments
-
The grinding segments are inserted intothe groove
and wedged outward by hammering slightly (soft-head
hammer).
-
When grinding, the centrifugal force presses the grin-
ding segments to the outside.
-
To replace worn segments, strike them to the inside
with a gentle hammer blow.
When centered, they can be removed easily.
► Depending on the subsoil, different numbers of dia-
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 | www.wolff-tools.de
mond segments can be used. By default, you use 4-9
segments. Always be fully aware that they are equally
distributed over the plate to avoid an imbalance.
3.3 Recommended segments (H)
► ES-segment: For preparing screed. For grinding
and removing sintered layers of screed and for
removing thin paint layers on soft mineral substra-
tes.
Diamond segment ES, grit 20
Diamond segment ES, grit 40
Diamond segment ES, grit 60
► PKD-segment:
For aggressive removal of PU coatings, putty mass
and tile adhesives (for thick adhesive layers).
► BT-segment: For preparing concrete substrates
For grinding concrete, coatings and highgrade
compounds and for removing thin paint layers on
hard substrates.
Diamond segment BT, grit 20
Diamond segment BT, grit 40
Diamond segment BT, grit 60
► PKD-splinter segment
For removing thin epoxy resin layers, paint,
synthetic resin, PU and dispersion adhesive. Well
suited for removing fleece backing and textile
double backing. (On hard sub-surfaces only.)
3.4 Set level regulator/body carriage (E)
► The machine must be positioned horizontally when
sanding/milling segments are attached.
For this purpose, the transport wheel (8) can be read
justed through the elongated holes of the level control
(7).
If the sanding segments have been used up, then
the machine may also be re-adjusted via the level
regulator (7) and positioned horizontally again.
The position may be checked using the provid
spirit level on the motor head.
#56306
#56308
#56309
#48028
#48038
#48041
#56303
#48036
EN
19
Publicité
Table des Matières
