Mounting The Hd Radio Tuner Unit - Kenwood KTC-HR100 Mode D'emploi

Mounting the HD Radio tuner unit

2CAUTION
• Install the HD Radio tuner unit in a well-ventilated location and do not place
objects on top of it.
• When installing to the car, the unit should be securely fastened at a location
that will not interfere with driving.
• When making a hole in the chassis, check that the gas tank, break pipe, wire
harness, or other part is not located on the other side, and be careful not to
cause scratches.
• When attaching the mounting fittings (Accessory2) to the HD Radio tuner
unit, use only the supplied mounting screws (Accessory3) (M4 x 8 mm).
Use of screws other than those supplied may result in internal damage or
insecure mounting and is very dangerous.
■ Installation using the self-tapping screws
Accessory2
Accessory4 (Ø5 × 20 mm)
Accessory3
(M4 × 8 mm)
Carpet
Board etc.
thickness: 20 mm or more
— 10 —
■ Installation using the velcro tapes
2CAUTION
Please do not install the unit near the dashboard, the rear tray, or other
important components. Doing so could lead to injury or accident should the
unit come off due to a shock and strike a person or an important component.
Tapping screws should be used for mounting. (Attachment with velcro strips,
although easy, can come off with a shock.)
Accessory5
Carpet