D+H VCD 204-K-TMS+ Set Notice Originale page 7

Masquer les pouces Voir aussi pour VCD 204-K-TMS+ Set:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Stroke limiting with magnets
B oth drives must be electrically connected in order to set the stroke.
Only one drive needs to be switched to the stroke learning mode with the magnet .
1
Close drives.
Mounting informations
Mount the drives mechanical stress-free.
With that, a better load distribution is ensured on all
the drives.
99.831.12 1.2/01/19
2
Voltage must continue to
be applied to the drives when
moving in the "CLOSE"
direction. Hold the magnet next
to the drive (...-B) as shown in the
diagramme (2 sec.) until you hear
a pulsating ton > The drives are
now in learning mode. The magnet
can now be removed and the drive
no longer has to be under voltage.
appr. 2 sec.
learning mode
Disposal
Electrical devices, accessories, batteries and packa-
ging should be sorted for environmental-friendly
recycling. Do not dispose electrical devices and
batteries into household waste!
Only for EC countries:
According the European Guideline 2012/19/EU for
waste electrical and electronic equipment and its
implementation into national right, electrcal devices
that are no longer usable must be collected separa-
tely and disposed of in an environmentally correct
manner.
English
3
Allow the drives to run
"OPEN" until you reach the
required stroke.
If the stroke is set incorrectly,
the procedure is accidentally
interrupted or the drives
continues to the full stroke
length, please return to point 1
and start again.
STOP
VCD 204 -K
7/16

Publicité

Table des Matières
loading

Table des Matières