2
6
5
7
9
4
Remove the power supply before
changing the blade! Unintended starting of the machine
may cause injury, e.g. of your hands.
01/2009
PIRANHA, Nr. 016927
5.3 Height adjustment
The height can be adjusted from 7 to 25 mm.
5.4 Depth adjustment
The depth can be adjusted from 0 to 50 mm
5.5 Replacement of blade
If the quality of the cuts is getting worse, the blade has to be
changed.
3
6.0 Trouble shooting
Trouble
Machine does not start
High expenditure of
force necessary
High vibration
Loosen thumb screw ( 2 )
Adjust demanded high by switching the spine shaft with the
socket spanner ( 3 )
See scale ( 4 ) at the front side of the machine.
Before starting work, check the adjustment
Loosen lever screw ( 5 ) of the bit stop
Adjust demanded depth by moving and fixing the bit stop
( 6 ). Pull lever screw ( 5 ) tight again.
Before starting work, check the adjustment using a sample
piece.
Losen knurled thumb screw ( 7 ) and remove button blade
( 8 ) backwards.
Block motor gear with fixing device ( 9 ). Release flange
( 10 ) through bore hole by using hexagon socket screw
driver and clean flange. Remove used blade
Install new blade and fix flange
Reinstall the cover and pull knurled thumb screw tight ( 7 ).
Eventual cause
Power supply disconnected
fuse or cable
defective cable or plug
Blade is blunt
Teeth of the blade are
broken of
Elimination
Have machine
repaired by a qualified
electrician
resp. change blade
Replace blade
Replace blade
12