HYGIPLAS DP028 Mode D'emploi page 3

DP028_ML_80x110mm_v4_20201112.indb 3 DP028_ML_80x110mm_v4_20201112.indb 3
Operation
1. Press [HR-MIN] and [MIN-SEC] to set the desired count down time.
2. Press [START/STOP] to start timer. The buzzer will sound when display
counts down to "00 00".
3. Press [START/STOP] to stop timer and the preset value will be
displayed.
4. Press [HR-MIN] and [MIN-SEC] simultaneously will clear display value
to "00 00".
5. Press [START/STOP] to start count up.
6. When the display counts up to the maximum range, it will re-count
from 0.
Remove the batteries if you will not be using the appliance for
an extended period of time.
Compliance
Dispose of depleted batteries in accordance with local regulations, within
the EC there are nominated disposal points for batteries.
The WEEE logo on this product or its documentation indicates
that the product must not be disposed of as household waste.
To help prevent possible harm to human health and/or the
environment, the product must be disposed of in an approved
and environmentally safe recycling process. For further
information on how to dispose of this product correctly, contact
the product supplier, or the local authority responsible for
waste disposal in your area.
HYGIPLAS parts have undergone strict product testing in order
to comply with regulatory standards and specifications set by
international, independent, and federal authorities.
HYGIPLAS products have been approved to carry the following
symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of HYGIPLAS.
Every effort is made to ensure all details are correct at the time of going to press, however, HYGIPLAS reserve
the right to change specifications without notice.
EN
3
2020/11/12 15:23 2020/11/12 15:23