Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
(4) When nish measuring an optic ber, press "
interface. Default lename is hour/minute/second of rst time storage. Press
Up/Down/Left/Right button to select alphabets, digits and symbols on
soft keyboard. You can input 23 alphabets at most. If "Automatic naming" is
enabled, the lename will automatically generated with four digits. Without
shutting down the device, the following stored le's name will automatically
plus 1. The le format is .SOR. On le recalling interface, press Right button can
Modify lename, as the same operations above.
7.2 Menu-Measure settings
Measure settings menu is used to set relative measurement data, which the
judgment of events list is based on. Wrong setting might leads to wrong or
missing events.
Wavelength---wavelength of laser.
Scan mode---manual and auto mode. Under auto mode, it will match the
distance, range and pulse width.
Range---match with the length of measured optic ber, usually over one level.
Pulse width---set the pulse width of output laser. Usually, small pulse width can
measure close event, large pulse width can measure remote distance, but enlarge
event's blind area.
Average time--- can set between 5 second and 180 second as average measure-
ment time.
Splice loss---treat as an event when the loss is higher than setting value.
Rename
File Name:
140950
Caps
a
c
e
b
d
h
j
i
k
l
p
q
o
r
s
y
x
z
v
w
" button to enter storage
File
back
Save
g
7
8
9
f
m
n
4
5
6
u
t
1
2
3
.
_
0
#
10
Publicité
Table des Matières
